Home > Turn Signal > Both Rear Turn Signals Not Working

Both Rear Turn Signals Not Working

Contents

Just go to your local auto parts store and buy 1156's for the turn signals. I'd start with checking the connectors near the light, then moving on to testing for voltage in and ground out. just not finding anything that has shows pinched or rubbed, or wear issues. Did you ever figure this out? Check This Out

I was driving around town today and I noticed my right turn signal on my dash was flashing very rapid. It took me 3 or 4 times to figure out it the bulbs were fine. Human Verification In order to verify that you are a human and not a spam bot, please enter the answer into the following box below based on the instructions contained in or test : Bypass the flasher by connecting a power wire (for instance #8 Violet) to the B/W/G wire from the signal switch. (Remember that the ignition switch must be on try here

Turn Signal Relay

Share Share this post on Digg Del.icio.us Technorati Twitter SoK66 is offline Quote Quick Reply post #18 of 30 Old 02-01-2014, 04:47 PM swrandles Newbie Join Date: Feb 2014 Symptom: Right turn signal (interior) starts fast flashing (indicating a bulb is burned out). I will do though....

Use a test light to test input and output power circuits using a wiring schematic. Next I replace the 15 amp in the fuse box. Will the top ones light up at all (park lights)? __________________ Please post all questions in the appropriate forum. Turn Signals Not Working At All You actuate signal on column, this then goes to BCM then distributed to where needed.

Could that REALLY be the problem? Turn Signals Not Working But Hazards Do Pleaselet me konw what is wrong. CORRECTIVE ACTIONPrior to performing extensive diagnosis, check the vehicles fuses to ensure they are not blown. their explanation When the switch is initially turned on, electrical current flows through the flasher unit to the bulbs.

I live in california 2 out of 2 people think this is helpful. Turn Signal Not Blinking Good luck 0 | Reply - Share Hide Replies ∧Richard9 months 26 days agoi replaced the multifunction switch on our 98 f150 xl 4.6l 2wd due to loss of turn singals Socal Xpress posted Nov 10, 2016 at 5:53 PM 2016 vnl 670 Jlaws7889 posted Nov 7, 2016 at 7:31 PM Stange Volvo d12 behavior... Taillights will work fine and at random I get the fast dash light flash indicating a bulb is out.

Turn Signals Not Working But Hazards Do

Thank you. 1 | Reply - Share Hide Replies ∧Gregg2 years 1 month agoI have a problem I've never seen before or heard of. http://www.hummerforums.com/forum/hummer-h3-17/both-rear-turn-signals-erratic-27553/ Sometimes it will not come back for days and will not stay working for more than a few miles on any day. Turn Signal Relay The time now is 08:12 PM. -- hummer37 Contact Us - Hummer Forums - Enthusiast Forum for Hummer Owners - Archive - Advertising - Cookie Policy - Privacy Statement - Terms Turn Signal Not Working On One Side Replaced the socket because it looked like it was burned too.

The fuse itself looks fine, but again I'm getting nothing when testing the fuse box. 07-08-2010, 02:29 PM #13 Midnight Tech AdministratorAutomotive Team Manager Join Date: Dec http://basetelecom.net/turn-signal/camaro-turn-signals-not-working.html User Name: Password Please enter a password for your user account. We use data about you for a number of purposes explained in the links below. Any help as always, appreciated. Brake Lights And Turn Signals Not Working

Checked the fuses under the hood and they were OK (unless there's another fuse panel I dont know about?). No turn signals still 1 answer My 94 dodge ram is having issues. Check out the Dynaverse! this contact form Checked both bulbs appear ok, but while in fast blink we know - NO rear turn signal and No rear brake lights. (except upper center bar light thankfully!).

Confession might be good for the soul, but it hurts the heart like hell. 07-08-2010, 12:47 PM #12 pspeir Registered Member Join Date: Jul 2010 Posts: 29 OS: Turn Signals And Hazards Not Working Some vehicles use a solid state flasher module that contains transistors and diodes. Best Answer Mark helpful 70 Report centerpoint04 answered 3 years ago I will try that first thing in the morning and report back with my findings.

If you test it outside the car, don't forget to ground the stud.

Additional giveaways are planned. Check out the Dynaverse! Now I can see it's just part of the glass. Brake Light And Turn Signal Not Working On One Side As we understand it.

Make sure you put some dielectric grease on the connector 12-19-2013, 08:39 PM usafracer Location: North Pole Alaska 885 posts, read 3,737,345 times Reputation: 773 The socket that the I went and bought high priced sylvanias and it seem to work. The signal and brake lights only work with the ignition switch on, so all the signaltests below assume that. navigate here The left side lights will work just fine every time, not the same with the right side though.

Still getting a rather standard 20mpg plus or minus 1mpg whether on highway or in town. Community Links Pictures & Albums User Tagging Statistics Hash Tag Subscriptions Search Forums Show Threads Show Posts Advanced Search Google Search Go to Page... Turns out it was the wiring harness for the taillight. Sometimes killing the engine and pulling key and then restarting resets the issue.

Carl's Corner - Auto Repair Help DIAGNOSE - THE TURN SIGNALS DON'T WORK OR DON'T WORK PROPERLYBy Carl O'Reilly SYMPTOM SUMMARYThe turn signals do not flash or they may We use data about you for a number of purposes explained in the links below. We have no electrical add ons, nothing to mess with the system. Ditto on if the lights on the Other side flash as normal.

hazards work though. Page 1 of 2 1 2 > City-Data Forum Message Cancel Changes Quick Reply The following errors occurred with your submission Okay Message: Posting Quick Reply - Please Wait I have replaced fuse after fuse, replaced multiple switches as well, also replaced the bulbs. You currently have 0 posts.

Right rear, works fine the first time I use it after even just turning the ignition on. i even got a new blinker swich thinking maybe it was that, but no my blinkers still do not work and i am using hand signals still this has b... 1996 No aftermarket anything yet, although LED rears are coming soon. Mark helpful 10 Report Stevan answered 5 months ago 2006 ram 1500 4.7L same exact issue, same exact right rear blinker.

We use data about you for a number of purposes explained in the links below. To view links or images in signatures your post count must be 0 or greater. Mark helpful 30 Report Mike answered 3 months ago I have a 2007 dodge ram . Looks like pricing between $160 and $220 for an OE?

They sell some on rockauto.com but look a lot smaller then stock and not sure if it would work.